Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026B9H |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: EXTERIOR PANELS / TRIM: REAR DOOR OUTSIDE MOULDING: INSTALLATION; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ] |
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. INSTALL GROMMET
(a) Perform this procedure only when replacement of the grommet is necessary.
(1) Install the 3 grommets.
2. INSTALL QUARTER OPENING RETAINER
(a) Perform this procedure only when replacement of the quarter opening retainer pad is necessary.
(1) Clean the outside moulding set.
1. Using a heat light, heat the outside moulding set surface.
HINT:
When installing the quarter opening retainer pad, heat the outside moulding set using a heat light.
Heating Temperature:
Item
|
Temperature
|
Outside Moulding Set
|
20 to 30 °C (68 to 86 °F)
|
CAUTION:
-
Do not touch the heat light and heated parts, touching the heat light may result in burns.
-
Touching heated parts for a long time may result in burns.
*a
|
Heated Part
|
*b
|
Heat Light
|
NOTICE:
Do not heat the outside moulding set excessively.
2. Remove any remaining double-sided tape from the outside moulding set.
3. Wipe off any tape adhesive residue with cleaner.
(2) Using a brush or felt, apply primer or equivalent to the quarter opening retainer installation area.
NOTICE:
-
Use a clean brush or felt.
-
Do not touch the outside moulding set until the primer has dried.
(3) Install a new quarter opening retainer.
1. Using a heat light, heat the outside moulding set surface.
2. Remove the release paper from the quarter opening retainer pad.
HINT:
After removing the release paper, keep the exposed adhesive free from foreign matter.
3. Install the quarter opening retainer pad as shown in the illustration.
Standard Measurement:
Area
|
Measurement
|
Area
|
Measurement
|
A
|
3 mm (0.118 in.)
|
B
|
3 mm (0.118 in.)
|
HINT:
Press the quarter opening retainer pad firmly to install it.
|
|
(b) Install the quarter opening retainer with the 3 screws.
3. INSTALL OUTSIDE MOULDING SET
(a) When reusing the outside moulding set:
(1) Install 6 new clips to the outside moulding set.
(b) Engage the 6 clips.
(c) Install the outside moulding set with the 3 clips.
|