Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026A6X |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function (Gasoline Model, TMMMS Made)): B279C95,B279C; Engine Immobiliser System Incorrect Assembly; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022] |
DTC
|
B279C95
|
Engine Immobiliser System Incorrect Assembly
|
DTC
|
B279C
|
Theft Deterrent System Presence Detection
|
DESCRIPTION
If an ECM that is incompatible with the immobiliser function is installed, the ECM will store this DTC.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
Note
|
B279C
|
Theft Deterrent System Presence Detection
|
An ECM that is incompatible with the immobiliser function is installed. (1-trip detection logic*)
|
ECM
|
-
|
B279C95
|
Engine Immobiliser System Incorrect Assembly
|
An ECM that is incompatible with the immobiliser function is installed. (1-trip detection logic*)
|
ECM
|
-
|
-
*: Only detected while a malfunction is present.
Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected
|
Fail-safe Function when Malfunction Detected
|
Engine cannot be started
|
-
|
Related Data List and Active Test
DTC No.
|
Data List and Active Test
|
|
-
|
-
*1: for M20A-FKS
-
*2: for 2ZR-FAE
CAUTION / NOTICE / HINT
NOTICE:
-
When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus Body Electrical Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
-
The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
Click here
-
Before replacing the ECM, refer to Registration.
Click here
-
After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
(a) Temporarily replace the ECM with a new one.
for M20A-FKS: Click here
for 2ZR-FAE: Click here
NEXT |
|
END (ECM WAS DEFECTIVE)
|
|