- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM10000000268JI |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - ] |
| Title: G16E-GTS (INTAKE / EXHAUST): EXHAUST PIPE: REMOVAL; 2023 - 2025 MY GR Corolla [09/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Gas leak from exhaust system is repaired |
Inspection After Repair |
|
|
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
PROCEDURE
1. REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY
Click here
![2023 - 2025 MY GR Corolla [09/2022 - ]; G16E-GTS (INTAKE / EXHAUST): EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE TAIL EXHAUST PIPE ASSEMBLY
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
3. REMOVE FRONT CENTER FLOOR BRACE
4. REMOVE FRONT FLOOR COVER LH
(1) Remove the 5 clips, 2 bolts and 4 screws.
(2) Turn the clip and remove the front floor cover LH from the vehicle body.
NOTICE:
If the clip is not turned when the front floor cover LH is removed, the front floor cover LH or stud bolt may be damaged.
HINT:
Do not remove the clip from the front floor cover LH.
5. REMOVE FRONT FLOOR COVER RH
(1) Remove the 5 clips, 2 bolts and 4 screws.
(2) Turn the clip and remove the front floor cover RH from the vehicle body.
NOTICE:
If the clip is not turned when the front floor cover RH is removed, the front floor cover RH or stud bolt may be damaged.
HINT:
Do not remove the clip from the front floor cover RH.
6. REMOVE NO. 1 CENTER FLOOR BRACE
7. REMOVE AIR FUEL RATIO SENSOR
Click here
8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
|
|