- Replacement of throttle body with motor assembly
- Cleaning the deposits from the throttle body with motor assembly
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM10000000268J7 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: G16E-GTS (INTAKE / EXHAUST): INTAKE MANIFOLD: REMOVAL; 2023 MY GR Corolla [09/2022 - 11/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection After Repair |
|
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![2019 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION](/t3Portal/stylegraphics/info.gif)
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System (for TMC Made) |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. |
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
4. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
5. DRAIN ENGINE COOLANT
Click here
6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
7. SEPARATE ENGINE WIRE
8. REMOVE NO. 4 WATER BY-PASS PIPE
9. SEPARATE NO. 1 FUEL VAPOR FEED HOSE
10. REMOVE WIRE HARNESS CLAMP BRACKET
11. REMOVE NO. 1 REMOVE TURBO PRESSURE SENSOR
12. REMOVE ENGINE WIRE
13. REMOVE WATER BY-PASS HOSE
14. REMOVE INTAKE AIR CONNECTOR BRACKET
15. REMOVE INTAKE MANIFOLD
|
Bolt |
|
Nut |
|
Clamp |
- |
- |
16. REMOVE NO. 1 VENTILATION FLANGE SEPARATOR
17. REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
18. REMOVE NO. 1 FUEL VAPOR FEED HOSE
19. REMOVE AIR TUBE ASSEMBLY
20. REMOVE THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY
21. REMOVE MANIFOLD TO CYLINDER HEAD GASKET
|
|