- Replacement of air fuel ratio sensor (sensor 1)
- Gas leak from exhaust system is repaired
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM10000000268I0 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - ] |
| Title: G16E-GTS (EMISSION CONTROL): MONOLITHIC CONVERTER: REMOVAL; 2023 - 2025 MY GR Corolla [09/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold converter sub-assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
CAUTION:
-
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
-
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
PROCEDURE
1. REMOVE WINDSHIELD WIPER MOTOR AND LINK
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; WIPER / WASHER: FRONT WIPER MOTOR: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL
Click here
3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
4. REMOVE DASH PANEL HEAT INSULATOR
5. REMOVE RADIATOR SUPPORT OPENING COVER
Click here
6. REMOVE INLET NO. 1 AIR CLEANER
7. REMOVE AIR CLEANER WITH AIR CLEANER HOSE
8. REMOVE INTAKE AIR RESONATOR
9. REMOVE NO. 1 AIR INLET DUCT
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
Click here
11. REMOVE AIR FUEL RATIO SENSOR
Click here
12. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
13. INSTALL EXHAUST PIPE CLAMP
14. REMOVE OUTLET TURBINE ELBOW GASKET
|
|