| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM10000000265QW |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model with Electric Parking Brake System TMMMS Made): Brake Actuator Operation Sound is Loud during Initial Check; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022] | ||
|
Brake Actuator Operation Sound is Loud during Initial Check |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Click here
![2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model with Electric Parking Brake System TMMMS Made): UTILITY](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
PERFORM ROAD TEST |
(a) After turning the engine switch on (IG), compare the operating sound of the brake actuator the first time the vehicle speed reaches 45 km/h (28 mph) with a known good vehicle of the same model.
OK:
The operating sound is the same or quieter than that of a known good vehicle of the same model.
HINT:
When the vehicle speed reaches approximately 40 km/h (25 mph), the initial check of the brake actuator assembly is performed and pump motor operation sounds are generated.
| OK |
|
END |
|
|
2. |
CHECK BRAKE ACTUATOR BRACKET CUSHION |
(a) Check that the cushion of the brake actuator bracket assembly is not worn, damaged or deformed.
OK:
The brake actuator bracket assembly is not worn, damaged or deformed.
| NG |
|
REPLACE BRAKE ACTUATOR BRACKET CUSHION |
|
|
3. |
ADJUST INSTALLATION OF BRAKE ACTUATOR ASSEMBLY |
(a) Drain the brake fluid.
(b) Disconnect all brake lines from the brake actuator assembly.
Click here
(c) Connect each brake line so that the cushion of the brake actuator assembly is tensioned evenly.
Click here
NOTICE:
After connecting all the brake lines, add brake fluid and bleed the brake system.
Click here
HINT:
By reducing the tension on the brake lines and cushion, the operating sound of the brake actuator assembly may be reduced.
(d) Check that no brake lines interfere the vehicle body or other components.
|
|
4. |
RECHECK SYMPTOM |
(a) Perform a road test and check the magnitude of the operating sound again.
OK:
The operating sound is the same or quieter than that of a known good vehicle of the same model.
| OK |
|
END |
| NG |
|
|
|