ADVANCED DRIVER ASSISTANCE SYSTEM: PRE-COLLISION SYSTEM (for TMMMS Made): U030051; Internal Control Module Software Incompatibility Not Programmed; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM10000000264EV
Model Year Start: 2023	Model: GR Corolla	Prod Date Range: [09/2022 - 11/2022]
Title: ADVANCED DRIVER ASSISTANCE SYSTEM: PRE-COLLISION SYSTEM (for TMMMS Made): U030051; Internal Control Module Software Incompatibility Not Programmed; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]

DTC

U030051

Internal Control Module Software Incompatibility Not Programmed

DESCRIPTION

The forward recognition camera receives vehicle information from the ECM via CAN communication.

If the forward recognition camera cannot store the vehicle information, it will store this DTC.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
U030051	Internal Control Module Software Incompatibility Not Programmed	When the ignition switch is ON for 3 seconds or more, the vehicle information sent from the ECM cannot be verified by the forward recognition camera for 3 seconds or more.	SFI system Forward recognition camera ECM

NOTICE:

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
If the forward recognition camera has been replaced with a new one, forward recognition camera adjustment must be performed.
HINT:

Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

One Time Recognition: Click here

Sequential Recognition: Click here

1.	CHECK FOR DTCs

(a) Using the GTS, check for SFI system DTCs.

(1) for M20A-FKS:

(2) for 2ZR-FAE:

Result	Proceed to
SFI system DTCs are not output	A
SFI system DTCs are output	B

GO TO SFI SYSTEM

for M20A-FKS: Click here

for 2ZR-FAE: Click here

2.	CHECK FOR DTCs (HEALTH CHECK)

(a) Connect the GTS to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: System Select / Health Check.

(e) Check DTCs.

(f) Turn the ignition switch off.

OK:

DTCs indicating a vehicle information mismatch with the ECM are not output by any ECU other than the forward recognition camera.

Result	Proceed to
DTCs are not output	A
DTCs are output	B

REPLACE ECM

for M20A-FKS: Click here

for 2ZR-FAE: Click here