Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000262LL |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (for Single Knob Type): Wi-Fi Connection History; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ] |
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Click here
PROCEDURE
1.
|
CHECK "Wi-Fi" SETTINGS
|
(a) Check that the following Wi-Fi connection settings are set as follows:
"Wi-Fi" is set to on.
NG |
|
PERFORM WI-FI SETTING AGAIN
|
OK
|
|
|
2.
|
CHECK CONDITIONS AND PROCEDURE
|
(a) Check the conditions and procedure for establishing a "Wi-Fi" connection, and perform the "Wi-Fi" connection procedure again.
HINT:
-
As there may be wave interference, disconnect other "Wi-Fi" compatible devices or "Bluetooth" compatible devices before establishing a "Wi-Fi" connection.
-
A "Wi-Fi" connection can be established manually or automatically.
-
There are 2 ways to establish a manual "Wi-Fi" connection. Connecting by searching for a "Wi-Fi" access point, and connecting by entering an SSID and password.
-
Even though an automatic connection is enabled, a connection can be established only when a "Wi-Fi" access point with the same SSID and password that were used for a previous connection exists.
Result
|
Proceed to
|
"Wi-Fi" connection can be established.
|
A
|
"Wi-Fi" connection cannot be established.
|
B
|
A |
|
END
|
B
|
|
|
3.
|
CHECK DEVICE TO BE CONNECTED VIA "Wi-Fi"
|
(a) Check the device to be connected via "Wi-Fi".
HINT:
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
Result
|
Proceed to
|
The in-vehicle device is trying to connect to the "Wi-Fi" access point of a portable device such as a mobile "Wi-Fi" router, tethering device, etc.
|
A
|
The in-vehicle device is trying to connect to a "Wi-Fi" access point other than a portable device.
|
B
|
A
|
|
|
(a) Bring a portable device to be used to establish a "Wi-Fi" connection near the in-vehicle device, and perform "Wi-Fi" connection again.
HINT:
-
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
-
Depending on the type of the portable device, customer operation such as internet sharing, tethering settings, etc., may be required whenever establishing a "Wi-Fi" connection.
Result
|
Proceed to
|
"Wi-Fi" connection can be established.
|
A
|
"Wi-Fi" connection cannot be established.
|
B
|
A |
|
END
|
(a) Move the vehicle to an access point where "Wi-Fi" connection can be established normally with other vehicles, and perform the "Wi-Fi" connection procedure again.
HINT:
-
When the in-vehicle device is connected to an outside "Wi-Fi" access point, the "Wi-Fi" connection will be disconnected if leaving the radio wave service area.
-
This function is not designed to be used while driving. Use this function only when the vehicle is stopped.
Result
|
Proceed to
|
"Wi-Fi" connection can be established.
|
A
|
"Wi-Fi" connection cannot be established.
|
B
|
A |
|
END (ACCESS POINT WAS ABNORMAL)
|
B
|
|
|
6.
|
CHECK "Wi-Fi" ACCESS POINT
|
(a) Bring a well-known portable device such as a mobile "Wi-Fi" router, tethering device, etc., near the in-vehicle device, and perform the "Wi-Fi" connection procedure again.
HINT:
-
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
-
Depending on the type of the portable device, customer operation such as internet sharing, tethering settings, etc., may be required whenever establishing a "Wi-Fi" connection.
Result
|
Proceed to
|
"Wi-Fi" connection can be established.
|
A
|
"Wi-Fi" connection cannot be established.
|
B
|
A |
|
END (ACCESS POINT WAS TEMPORARY ABNORMAL)
|
7.
|
CHECK RESULT OF "Wi-Fi Connection History"
|
(a) Check the wave interference while a "Wi-Fi" connection is established.
HINT:
-
Check the "W-Fi Connection History" around the time that the malfunction occurred.
-
Using the GTS, proceed to the appropriate link in accordance with the result of "Wi-Fi Connection History".
Click here
Result
|
Proceed to
|
"Received Signal Strength" is -71 dBm or less
|
A
|
"Data Rate" is "Slow Speed"
|
"Packet Error Rate" is 5% or more
|
"Result" is "Connection Failure (Authentication Failure)"
|
B
|
"Result" is "Connection Failure (Time Out)"
|
C
|
None of the above
|
D
|
A |
|
ESTABLISH "WI-FI" CONNECTION IN AREA WITH LITTLE WAVE INTERFERENCE
|
B |
|
EXPLAIN TO CUSTOMER THAT THERE WAS POSSIBILITY THAT USED PASSWORD WAS NOT CORRECT
|
C |
|
CHECK POWER AND CHARGING STATE OF CONNECTED EXTERNAL DEVICE, AND RESTART IT AND PERFORM "WI-FI" CONNECTION PROCEDURE AGAIN
|
|