Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000262E0 |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: G16E-GTS (BATTERY / CHARGING): BATTERY CURRENT SENSOR: REMOVAL; 2023 MY GR Corolla [09/2022 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System (for TMC Made)
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. REMOVE BATTERY STATE SENSOR ASSEMBLY
(a) for Type A:
(1) Remove spare wheel cushion.
Click here
(b) Disconnect the battery state sensor assembly connector.
|
|
*A
|
for Type A
|
*B
|
for Type B
|
|
|
(c) Remove the nut and disconnect the earth wire from the battery state sensor assembly.
|
|
*A
|
for Type A
|
*B
|
for Type B
|
|
|
(d) Loosen the nut and remove the battery state sensor assembly from the battery.
|
|
*A
|
for Type A
|
*B
|
for Type B
|
|
|
|