NOTICE:

• When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Key(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
• If the certification ECU (smart key ECU assembly) is replaced, refer to the Smart Key System (for start function).

  for HV Model: Click here

  for Gasoline Model: Click here

• When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, the performance of the entry function and wireless function may be affected.
• This DTC is not stored within 10 seconds of the ignition switch being turned from on to off.
• Make sure that there are no electrical key transmitter sub-assemblies in the vehicle.
• If the door control receiver has been replaced, it is necessary to perform initialization (Click here ) after registration (Click here ) of the transmitter IDs to the door control receiver assembly.
• When replacing the door control receiver, read the transmitter IDs (tire pressure warning system) stored in the old ECU using the GTS and write them down before removal.

  Click here