Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000260RN |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): C050C1F; Left Rear Wheel Speed Sensor Circuit Intermittent; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 - ] |
DTC
|
C050C1F
|
Left Rear Wheel Speed Sensor Circuit Intermittent
|
DESCRIPTION
Refer to DTC C050C12.
Click here
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
C050C1F
|
Left Rear Wheel Speed Sensor Circuit Intermittent
|
Any of the following is detected:
-
When the +BS terminal voltage is 17.4 V or less, an open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.
-
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.
-
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.
|
-
Rear speed sensor LH
-
Speed sensor installation
-
Rear speed sensor rotor LH (rear axle hub and bearing assembly LH)
|
PROCEDURE
1.
|
READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
RL Wheel Speed
|
Rear wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
RL Speed Open
|
Rear speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
RL Wheel Speed
|
RL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
NG
|
|
|
2.
|
CHECK REAR SPEED SENSOR LH INSTALLATION
|
(a) Turn the ignition switch off.
|
|
*1
|
Rear Speed Sensor LH
|
*a
|
Correct
|
*b
|
Incorrect
|
*c
|
8.5 N*m (87 kgf*cm, 75 in.*lbf)
|
*d
|
No clearance
|
|
|
(b) Check the rear speed sensor LH installation.
OK:
There is no clearance between the rear speed sensor LH and the rear axle carrier LH.
The installation bolt is tightened properly.
Torque
8.5 N*m (87 kgf*cm, 75 in.*lbf)
OK
|
|
|
3.
|
CHECK REAR SPEED SENSOR LH (CHECK FOR FOREIGN MATTER)
|
(a) Remove the rear speed sensor LH, and confirm that there is no foreign matter, oil or grease on the rear speed sensor tip LH.
OK:
The rear speed sensor tip LH is free of oil and foreign matter.
HINT:
If foreign matter of 1mm x 1mm or more is adhered to the rear speed sensor LH, this DTC may be stored.
OK
|
|
|
4.
|
CHECK REAR SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)
|
(a) Confirm that there is no foreign matter, oil or grease on the rear speed sensor rotor LH.
OK:
The rear speed sensor rotor LH is free of oil and foreign matter.
HINT:
-
If foreign matter of 1mm x 1mm or more is adhered to the rear speed sensor rotor LH, this DTC may be stored.
-
The rear speed sensor rotor LH is incorporated into the rear axle hub and bearing assembly LH.
-
If the rear speed sensor rotor LH needs to be replaced, replace it together with the rear axle hub and bearing assembly LH.
OK |
|
REPLACE REAR SPEED SENSOR LH AND REAR SPEED SENSOR ROTOR LH
for Rear Speed Sensor LH: Click here
for Rear Speed Sensor Rotor LH: Click here
|
NG
|
|
|
5.
|
CLEAN REAR SPEED SENSOR ROTOR LH
|
(a) Clean the rear speed sensor rotor LH.
NOTICE:
Do not use parts cleaner when cleaning the rear speed sensor rotor LH.
NEXT
|
|
|
6.
|
READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
RL Wheel Speed
|
Rear wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
RL Speed Open
|
Rear speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
RL Wheel Speed
|
RL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
HINT:
-
The rear speed sensor rotor LH is incorporated into the rear axle hub and bearing assembly LH.
-
If the rear speed sensor rotor LH needs to be replaced, replace it together with the rear axle hub and bearing assembly LH.
OK |
|
END
|
NG |
|
REPLACE REAR SPEED SENSOR LH AND REAR SPEED SENSOR ROTOR LH
for Rear Speed Sensor LH: Click here
for Rear Speed Sensor Rotor LH: Click here
|
7.
|
CLEAN REAR SPEED SENSOR LH
|
(a) Clean the rear speed sensor LH.
NOTICE:
When cleaning the rear speed sensor LH, make sure to clean the installation hole before installation.
NEXT
|
|
|
8.
|
READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
RL Wheel Speed
|
Rear wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
RL Speed Open
|
Rear speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
RL Wheel Speed
|
RL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
OK |
|
END
|
|