Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM10000000260RF
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 - 11/2022]
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): C050023; Left Front Wheel Speed Sensor Signal Stuck Low; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022]

DTC

C050023

Left Front Wheel Speed Sensor Signal Stuck Low

DESCRIPTION

Refer to DTC C050012.

Click here 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 -        ]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): C050012; Left Front Wheel Speed Sensor Circuit Short to Battery

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C050023

Left Front Wheel Speed Sensor Signal Stuck Low

Any of the following is detected:

  • When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors for 30 seconds or more.
  • When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more.
  • When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, outputs from both front speed sensors are 0 km/h (0 mph) for 30 seconds or more.
  • Speed sensor installation
  • Wire harness and connector
  • Front speed sensor LH
  • Front speed sensor rotor LH (front axle hub sub-assembly LH)

WIRING DIAGRAM

Refer to DTC C050012.

Click here 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 -        ]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): C050012; Left Front Wheel Speed Sensor Circuit Short to Battery

PROCEDURE

1.

CHECK FRONT SPEED SENSOR LH INSTALLATION

(a) Check the front speed sensor LH installation.

OK:

There is no clearance between the front speed sensor LH and front steering knuckle LH.

The installation bolt is tightened properly.

Torque

8.5 N*m (87 kgf*cm, 75 in.*lbf)

*1

Front Speed Sensor LH

*a

Correct

*b

Incorrect

*c

8.5 N*m (87 kgf*cm, 75 in.*lbf)

*d

No clearance
NG

REINSTALL OR REPLACE FRONT SPEED SENSOR LH

OK

2.

CHECK FRONT SPEED SENSOR LH (CHECK FOR FOREIGN MATTER)

(a) Remove the front speed sensor LH.

Click here 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

(b) Check the front speed sensor tip LH.

OK:

The front speed sensor tip LH is free of scratches, oil, and foreign matter.

NOTICE:

  • If there is oil or foreign matter on the front speed sensor LH, clean the front speed sensor LH.
  • If the front speed sensor LH is damaged, replace the front speed sensor LH with a new one.
NG

CLEAN OR REPLACE FRONT SPEED SENSOR LH
OK

3.

READ VALUE USING GTS (FL WHEEL SPEED)

(a) Start the engine.

(b) Perform a road test.

(c) Check the front speed sensor LH output value.

Chassis > Brake/EPB > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

FL Wheel Speed

Front wheel speed sensor LH reading

Min.: 0.0 km/h (0.0 mph)

Max.: 6553.5 km/h (4072 mph)

Vehicle stopped: 0.0 km/h (0.0 mph)

When driving at constant speed: No large fluctuations

Chassis > Brake/EPB > Data List

Tester Display

FL Wheel Speed

OK:

The output value changes in accordance with the vehicle speed.

OK

USE SIMULATION METHOD TO CHECK

NG

4.

CHECK HARNESS AND CONNECTOR (FRONT SPEED SENSOR LH - BRAKE ACTUATOR ASSEMBLY)

(a) Turn the ignition switch off.

(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.

OK:

The connector is securely connected.

(c) Disconnect the A13 front speed sensor LH connector.

(d) Disconnect the A140 skid control ECU (brake actuator assembly) connector.

(e) Check both the connector case and the terminals for deformation and corrosion.

OK:

No deformation or corrosion.

(f) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A13-2 (FL+) - A140-22 (FL+)

Always

Below 1 Ω

A13-2 (FL+) or A140-22 (FL+) - Body ground

Always

10 kΩ or higher

A13-1 (FL-) - A140-21 (FL-)

Always

Below 1 Ω

A13-1 (FL-) or A140-21 (FL-) - Body ground

Always

10 kΩ or higher
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

5.

CHECK FRONT SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)

(a) Remove the component with the front speed sensor rotor LH.

Click here 2023 - 2025 MY GR Corolla [09/2022 -        ]; AXLE AND DIFFERENTIAL: FRONT AXLE HUB (for G16E-GTS): REMOVAL

(b) Check the front speed sensor rotor LH.

OK:

The front speed sensor rotor LH is free of scratches, oil, and foreign matter.

NOTICE:

  • If there is oil or foreign matter on the front speed sensor rotor LH, clean the front speed sensor rotor LH.
  • Do not use parts cleaner when cleaning the front speed sensor rotor LH.
  • If the front speed sensor rotor LH is damaged, replace the front speed sensor rotor LH with a new one.

HINT:

  • The front speed sensor rotor LH is incorporated into the front axle hub sub-assembly LH.
  • If the front speed sensor rotor LH needs to be replaced, replace it together with the front axle hub sub-assembly LH.

Result

Proceed to

OK

A

NG (The front speed sensor rotor LH is damaged.)

B

NG (There is foreign matter on the front speed sensor rotor LH.)

C
A

REPLACE FRONT SPEED SENSOR LH

B

REPLACE FRONT AXLE HUB SUB-ASSEMBLY LH

C

CLEAN FRONT SPEED SENSOR ROTOR LH