Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000260RE |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): C05001F; Left Front Wheel Speed Sensor Circuit Intermittent; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 - ] |
DTC
|
C05001F
|
Left Front Wheel Speed Sensor Circuit Intermittent
|
DESCRIPTION
Refer to DTC C050012.
Click here
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
C05001F
|
Left Front Wheel Speed Sensor Circuit Intermittent
|
Any of the following is detected:
-
When the +BS terminal voltage is 17.4 V or less, an open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.
-
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.
-
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.
|
-
Front speed sensor LH
-
Speed sensor installation
-
Front speed sensor rotor LH (front axle hub sub-assembly LH)
|
PROCEDURE
1.
|
READ VALUE USING GTS (FL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
FL Wheel Speed
|
Front wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
FL Speed Open
|
Front speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
FL Wheel Speed
|
FL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
NG
|
|
|
2.
|
CHECK FRONT SPEED SENSOR LH INSTALLATION
|
(a) Turn the ignition switch off.
|
|
*1
|
Front Speed Sensor LH
|
*a
|
Correct
|
*b
|
Incorrect
|
*c
|
8.5 N*m (87 kgf*cm, 75 in.*lbf)
|
*d
|
No clearance
|
|
|
(b) Check the front speed sensor LH installation.
OK:
There is no clearance between the front speed sensor LH and front steering knuckle LH.
The installation bolt is tightened properly.
Torque
8.5 N*m (87 kgf*cm, 75 in.*lbf)
OK
|
|
|
3.
|
CHECK FRONT SPEED SENSOR LH (CHECK FOR FOREIGN MATTER)
|
(a) Remove the front speed sensor LH, and confirm that there is no foreign matter, oil or grease on the front speed sensor tip LH.
OK:
The front speed sensor tip LH is free of oil and foreign matter.
HINT:
If foreign matter of 1mm x 1mm or more is adhered to the front speed sensor LH, this DTC may be stored.
OK
|
|
|
4.
|
CHECK FRONT SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)
|
(a) Confirm that there is no foreign matter, oil or grease on the front speed sensor rotor LH.
OK:
The front speed sensor rotor LH is free of oil and foreign matter.
HINT:
-
If foreign matter of 1mm x 1mm or more is adhered to the front speed sensor rotor LH, this DTC may be stored.
-
The front speed sensor rotor LH is incorporated into the front axle hub sub-assembly LH.
-
If the front speed sensor rotor LH needs to be replaced, replace it together with the front axle hub sub-assembly LH.
OK |
|
REPLACE FRONT SPEED SENSOR LH AND FRONT SPEED SENSOR ROTOR LH
for Front Speed Sensor LH: Click here
for Front Speed Sensor Rotor LH: Click here
|
NG
|
|
|
5.
|
CLEAN FRONT SPEED SENSOR ROTOR LH
|
(a) Clean the front speed sensor rotor LH.
NOTICE:
Do not use parts cleaner when cleaning the front speed sensor rotor LH.
NEXT
|
|
|
6.
|
READ VALUE USING GTS (FL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
FL Wheel Speed
|
Front wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
FL Speed Open
|
Front speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
FL Wheel Speed
|
FL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
HINT:
-
The front speed sensor rotor LH is incorporated into the front axle hub sub-assembly LH.
-
If the front speed sensor rotor LH needs to be replaced, replace it together with the front axle hub sub-assembly LH.
OK |
|
END
|
NG |
|
REPLACE FRONT SPEED SENSOR LH AND FRONT SPEED SENSOR ROTOR LH
for Front Speed Sensor LH: Click here
for Front Speed Sensor Rotor LH: Click here
|
7.
|
CLEAN FRONT SPEED SENSOR LH
|
(a) Clean the front speed sensor LH.
NOTICE:
When cleaning the front speed sensor LH, make sure to clean the installation hole before installation.
NEXT
|
|
|
8.
|
READ VALUE USING GTS (FL WHEEL SPEED, MOMENTARY INTERRUPTION)
|
(a) While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.
Click here
Chassis > Brake/EPB > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
FL Wheel Speed
|
Front wheel speed sensor LH reading
|
Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
|
Vehicle stopped: 0.0 km/h (0.0 mph)
|
When driving at constant speed: No large fluctuations
|
FL Speed Open
|
Front speed sensor LH open detection
|
Normal / Under intermittent
|
Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
|
-
|
Chassis > Brake/EPB > Data List
Tester Display
|
FL Wheel Speed
|
FL Speed Open
|
OK:
The values change in accordance with the operation of the vehicle and there is no intermittent operation.
NOTICE:
Perform the above inspection before removing the sensor and connector.
OK |
|
END
|
|