Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM1000000025YWO
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 -           ]
Title: DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the propeller with center bearing shaft assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Gas leak from exhaust system is repaired

Inspection after repair

  • Poor idle, etc.
  • Engine start function, etc.

2023 - 2025 MY GR Corolla [09/2022 -        ]; G16E-GTS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

Click here 2023 - 2025 MY GR Corolla [09/2022 -        ]; G16E-GTS (INTAKE / EXHAUST): EXHAUST PIPE: REMOVAL

2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY

(a) Remove the 2 nuts and front No. 1 floor heat insulator sub-assembly from the vehicle body.

3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(a) Remove the 2 bolts and 2 center No. 2 support bearing washers, and separate the center support bearing.

(b) Place matchmarks on the rear differential carrier assembly and propeller with center bearing shaft assembly.

*a

Matchmark

(c) Remove the 4 nuts and 4 washers, and separate the propeller with center bearing shaft assembly from the rear differential carrier assembly.

(d) Place matchmarks on the transfer assembly and propeller with center bearing shaft assembly.

*a

Matchmark

(e) Remove the 4 nuts and 4 washers, and separate the propeller with center bearing shaft assembly from the transfer assembly.