- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000025YWO |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - ] |
| Title: DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the propeller with center bearing shaft assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Gas leak from exhaust system is repaired |
Inspection after repair |
|
|
PROCEDURE
1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
Click here
![2023 - 2025 MY GR Corolla [09/2022 - ]; G16E-GTS (INTAKE / EXHAUST): EXHAUST PIPE: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY
|
(a) Remove the 2 nuts and front No. 1 floor heat insulator sub-assembly from the vehicle body. |
|
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
|
(a) Remove the 2 bolts and 2 center No. 2 support bearing washers, and separate the center support bearing. |
|
|
(b) Place matchmarks on the rear differential carrier assembly and propeller with center bearing shaft assembly. |
|
(c) Remove the 4 nuts and 4 washers, and separate the propeller with center bearing shaft assembly from the rear differential carrier assembly.
|
(d) Place matchmarks on the transfer assembly and propeller with center bearing shaft assembly. |
|
(e) Remove the 4 nuts and 4 washers, and separate the propeller with center bearing shaft assembly from the transfer assembly.
|
|