Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000025Y1I |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: G16E-GTS (ENGINE CONTROL): AIR FUEL RATIO SENSOR (for Sensor 2): REMOVAL; 2023 - 2025 MY GR Corolla [09/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Replacement of air fuel ratio sensor (sensor 2)
-
Gas leak from exhaust system is repaired
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
PROCEDURE
1. REMOVE FRONT CENTER FLOOR BRACE
Click here
2. REMOVE AIR FUEL RATIO SENSOR
(a) Disconnect the air fuel ratio sensor connector.
|
|
(b) Disengage the 2 wire harness clamps.
(c) Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly.
SST: 09224-00012
NOTICE:
If the air fuel ratio sensor has been struck or dropped, replace it.
|
|
|