Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM1000000025Y0R
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 -           ]
Title: G16E-GTS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: INSTALLATION; 2023 - 2025 MY GR Corolla [09/2022 -        ]

INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Perform this procedure only when reusing the crankshaft position sensor.

(1) Clean the O-ring groove of the crankshaft position sensor.

NOTICE:

Make sure the O-ring groove is free of foreign matter.

(2) Install a new O-ring to the crankshaft position sensor.

NOTICE:

Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.

(3) Check if the O-ring is twisted.

HINT:

Check the entire circumference of the seam of the O-ring for twisting.

*1

O-ring

*a

OK

*b

NG

*c

Seam

(b) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

(c) Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

  • If the crankshaft position sensor has been struck or dropped, replace it.
  • Make sure that the O-ring is not cracked or does not move out of place during installation.

(d) Connect the crankshaft position sensor connector.

2. INSTALL STARTER ASSEMBLY

Click here 2023 - 2025 MY GR Corolla [09/2022 -        ]; G16E-GTS (STARTING): STARTER: INSTALLATION