Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000025Y0Q |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: G16E-GTS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: REMOVAL; 2023 MY GR Corolla [09/2022 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System (for TMC Made)
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. REMOVE STARTER ASSEMBLY
Click here
2. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the crankshaft position sensor connector.
|
|
(b) Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
NOTICE:
If the crankshaft position sensor has been struck or dropped, replace it.
(c) Perform this procedure only when reusing the crankshaft position sensor.
(1) Remove the O-ring from the crankshaft position sensor.
NOTICE:
-
Make sure to only remove the O-ring with bare hands.
-
When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
-
If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.
|
|
|