| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000025VOB |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: NETWORKING: NETWORK GATEWAY ECU: REMOVAL; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] | ||
REMOVAL
PROCEDURE
1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV [09/2022 - 11/2022]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (except G16E-GTS): REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Click here
3. REMOVE FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Click here
5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Click here
6. REMOVE NO. 2 INSTRUMENT SIDE PANEL
Click here
7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Click here
9. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
10. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
12. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
13. REMOVE ECU INTEGRATION BOX RH (for TMMMS Made)
(a) Disconnect each connector.
|
(b) Disengage the 2 clamps. |
|
(c) Remove the 2 nuts, bolt and ECU integration box RH.
|
Nut |
|
Bolt |
14. REMOVE ECU INTEGRATION BOX RH (for TMC Made)
(a) Disconnect each connector.
|
(b) Disengage the 2 clamps. |
|
(c) Remove the 2 nuts, bolt and ECU integration box RH.
|
|
Nut |
|
|
Bolt |
15. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for TMMMS Made)
(a) Disengage the 2 claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.
|
Remove in this Direction |
NOTICE:
- If the ECU integration box RH is deformed or damaged, replace it.
- Do not bend the 2 claws more than necessary.
16. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for TMC Made)
(a) Disengage the 2 claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.
|
|
Remove in this Direction |
NOTICE:
- If the ECU integration box RH is deformed or damaged, replace it.
- Do not bend the 2 claws more than necessary.
|
|