| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM1000000025RI0 |
| Model Year Start: 2023 | Model: Corolla Hatchback | Prod Date Range: [09/2022 - ] |
| Title: M20A-FKS (COOLING): THERMOSTAT (w/ Cooling Fan ECU): INSPECTION; 2023 - 2025 MY Corolla Corolla Hatchback [09/2022 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
CAUTION:
- Do not put your hands into the water that has been heated for the inspection.
- Touching the heated water could result in burns.
HINT:
The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly.
(a) Immerse the water inlet with thermostat sub-assembly in water and then gradually heat the water.
NOTICE:
Do not allow any water to come into contact with the connector of the water inlet with thermostat sub-assembly.
(b) Check that the valve of the water inlet with thermostat sub-assembly opens at the specified temperature.
Standard Valve Opening Temperature:
80 to 84°C (176 to 183°F)
If the result is not as specified, replace the water inlet with thermostat sub-assembly.
|
(c) Check the valve lift. Standard Valve Lift: 8.0 mm (0.315 in.) or more at 95°C (203°F) If the result is not as specified, replace the water inlet with thermostat sub-assembly. |
|
(d) Check that the valve is fully closed when the water inlet with thermostat sub-assembly is at low temperatures (below 72°C (162°F)).
If it is not fully closed, replace the water inlet with thermostat sub-assembly.
|
|