| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000025OKM |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: EXTERIOR PANELS / TRIM: FRONT BUMPER (for Sedan with Illumination): INSTALLATION; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] | ||
INSTALLATION
CAUTION / NOTICE / HINT
for TMC Made:
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
for Target Adjustment (Triangle Target):
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; ADVANCED DRIVER ASSISTANCE SYSTEM: MILLIMETER WAVE RADAR SENSOR (for TMC Made): TARGET ADJUSTMENT(TRIANGLE TARGET)](/t3Portal/stylegraphics/info.gif)
for Target Adjustment (Flat Surface Target):
Click here
for Driving Adjustment:
Click here
for TMMMS Made:
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click here
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Move the front bumper assembly into position and engage the 5 claws as shown in the illustration.
|
Install in this Direction |
(b) Install the bolt and 2 screws.
(c) Pull back the side of the front bumper assembly and connect the connector.
NOTICE:
Do not apply excessive force when pulling back the front bumper assembly.
HINT:
Use the same procedure for the RH side and LH side.
(d) w/ Pre-collision System:
(1) Connect the connector.
(e) Engage the 4 claws as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
|
|
Install in this Direction |
(f) Install the 10 screws.
(g) Engage the 2 claws as shown in the illustration.
|
|
Install in this Direction |
HINT:
Use the same procedure for the RH side and LH side.
(h) Install the front bumper assembly with the 2 clips.
2. INSTALL RADIATOR SUPPORT OPENING COVER (for Gasoline Model)
(a) for TMMMS Made:
(1) Engage the guide as shown in the illustration.
|
|
Install in this Direction (1) |
|
Install in this Direction (2) |
(2) Install the radiator support opening cover with the 8 clips.
(b) for TMC Made:
(1) Install the radiator support opening cover with the 7 clips.
3. INSTALL RADIATOR SUPPORT OPENING COVER (for HV Model)
(a) Install the radiator support opening cover with the 6 clips.
|
|