Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM1000000025NW8
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 - 11/2022]
Title: LIGHTING (INT): PERSONAL LIGHT: INSPECTION; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]

INSPECTION

PROCEDURE

1. INSPECT MAP LIGHT SUB-ASSEMBLY (for TMC Made)

(a) Resistance Check

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (RLMP) - 1 (DOOR)

Door linked switch on

Below 1 Ω

2 (RLMP) - 11 (GND)

Dome light switch on

Below 1 Ω

If the result is not as specified, replace the map light sub-assembly.

*a

Component without harness connected

(Map Light Sub-assembly)

(b) Illumination Inspection

(1) Apply battery voltage to the map light sub-assembly and check that the lights illuminate.

OK:

Measurement Condition

Condition

Specified Condition

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switch LH on

Front map light LH illuminates

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switch RH on

Front map light RH illuminates

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switches off and dome light switch on

Front map light LH and RH illuminate

Battery positive (+) → 10 (+B1)

Battery negative (-) → 1 (DOOR)

Front map light switches off and door linked switch on

Front map light LH and RH illuminate

If the result is not as specified, replace the bulb or map light sub-assembly.

2. INSPECT MAP LIGHT ASSEMBLY (for TMMMS Made)

(a) Resistance Check

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (RLMP) - 1 (DOOR)

Door linked switch on

Below 1 Ω

2 (RLMP) - 11 (GND)

Dome light switch on

Below 1 Ω

If the result is not as specified, replace the map light assembly.

*a

Component without harness connected

(Map Light Assembly)

(b) Illumination Inspection

(1) Apply battery voltage to the map light assembly and check that the lights illuminate.

OK:

Measurement Condition

Condition

Specified Condition

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switch LH on

Front map light LH illuminates

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switch RH on

Front map light RH illuminates

Battery positive (+) → 10 (+B1)

Battery negative (-) → 11 (GND)

Front map light switches off and dome light switch on

Front map light LH and RH illuminate

Battery positive (+) → 10 (+B1)

Battery negative (-) → 1 (DOOR)

Front map light switches off and door linked switch on

Front map light LH and RH illuminate

If the result is not as specified, replace the bulb or map light assembly.