- Back door opener
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000025FXS |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: MAINTENANCE: G16E-GTS BATTERY: REMOVAL; 2023 MY GR Corolla [09/2022 - 11/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.
NOTICE:
- When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
- After replacing the battery, install the ventilation hole plug supplied with the new battery or the ventilation hole plug from the old battery to the ventilation hole on the side to which the battery hose is not connected.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System (for TMC Made) |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. |
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Power Door Lock Control System |
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ]; SETUP: WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL: BEFORE DISCONNECTING BATTERY](/t3Portal/stylegraphics/info.gif)
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. REMOVE SPARE WHEEL CUSHION
Click here
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
(a) Loosen the nut and disconnect the cable from the negative (-) battery terminal. |
|
5. REMOVE BATTERY
|
(a) Disengage the claw to remove the battery terminal connector cover. |
|
|
(b) Loosen the nut. |
|
(c) Disengage the spring assembly and disconnect the cable from the positive (+) battery terminal.
|
Remove in this Direction |
|
(d) Disconnect the battery hose from the battery. |
|
|
(e) Remove the nut, bolt and battery clamp sub-assembly from the body. |
|
(f) Remove the battery.
|
|