Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000025DVN |
Model Year Start: 2023 |
Model: Corolla |
Prod Date Range: [09/2022 -
] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model): C055595; Left Front Wheel Speed Sensor Incorrect Component Installed; 2023 - 2025 MY Corolla Corolla HV [09/2022 - ] |
DTC
|
C055595
|
Left Front Wheel Speed Sensor Incorrect Component Installed
|
DESCRIPTION
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
MIL
|
DTC Output from
|
Note
|
C055595
|
Left Front Wheel Speed Sensor Incorrect Component Installed
|
The front speed sensor LH is installed incorrectly.
|
Front speed sensor LH
|
Comes on
|
Brake/EPB
|
-
SAE Code: C0555
-
Output ECU: skid control ECU (brake actuator assembly)
|
MONITOR DESCRIPTION
The skid control ECU (brake actuator assembly) has a speed sensor circuit self-diagnosis function.
When the vehicle is stopped, the speed sensor supply voltage exceeds a certain value, and the self-diagnosis function detects an incorrectly installed speed sensor, the skid control ECU (brake actuator assembly) illuminates the MIL and stores this DTC.
MONITOR STRATEGY
Related DTCs
|
C0555 (Case 1): Wheel speed sensor wrong sensor type monitoring for FL (PWM intelligent sensor)
C0555 (Case 2): Wheel speed sensor wrong sensor type monitoring for FL (standard sensor)
C0555 (Case 3): Wheel speed sensor wrong sensor type monitoring for FL (intelligent sensor)
|
Required Sensors/Components(Main)
|
Skid control ECU (brake actuator assembly)
|
Required Sensors/Components(Related)
|
Skid control ECU (brake actuator assembly)
Speed sensor
|
Frequency of Operation
|
Continuous
|
Duration
|
3 seconds
|
MIL Operation
|
2 driving cycles
|
Sequence of Operation
|
None
|
TYPICAL ENABLING CONDITIONS
Monitor runs whenever the following DTCs are not stored
|
TMC's intellectual property
|
Other conditions belong to TMC's intellectual property
|
-
|
TYPICAL MALFUNCTION THRESHOLDS
TMC's intellectual property
|
-
|
COMPONENT OPERATING RANGE
TMC's intellectual property
|
-
|
CONFIRMATION DRIVING PATTERN
NOTICE:
When performing the normal judgment procedure, make sure that the driver door is closed and is not opened at any time during the procedure.
HINT:
-
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
-
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
-
Connect the GTS to the DLC3.
-
Turn the ignition switch to ON and turn the GTS on.
-
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
-
Turn the ignition switch off.
-
Turn the ignition switch to ON (READY) and turn the GTS on.
-
Wait for 3 seconds or more. [*]
HINT:
[*]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
-
Enter the following menus: Chassis / Brake/EPB* / Utility / All Readiness.
*: Electric Parking Brake System
-
Check the DTC judgment result.
HINT:
-
If the judgment result shows NORMAL, the system is normal.
-
If the judgment result shows ABNORMAL, the system has a malfunction.
-
If the judgment result shows INCOMPLETE, perform driving pattern again.
PROCEDURE
1.
|
CHECK PART NUMBER (FRONT SPEED SENSOR LH)
|
(a) Check that the front speed sensor LH is installed.
OK:
Proper front speed sensor LH is installed.
NOTICE:
If it is necessary to remove components in order to check the front speed sensor LH, follow the relevant installation and removal procedures and precautions for those components.
OK
|
|
|
(a) Clear the DTCs.
Chassis > Brake/EPB > Clear DTCs
(b) Turn the ignition switch off.
NEXT
|
|
|
(a) Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
(b) Check if the same DTC is output.
Chassis > Brake/EPB > Trouble Codes
Result
|
Proceed to
|
DTC C055595 is not output.
|
A
|
DTC C055595 is output.
|
B
|
|