Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM1000000025DLS
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 - 11/2022]
Title: LIGHTING (EXT): LIGHTING SYSTEM (for TMC Made): Parking Light/Daytime Running Light Circuit; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]

Parking Light/Daytime Running Light Circuit

DESCRIPTION

The main body ECU (multiplex network body ECU) controls the parking lights and daytime running lights.

WIRING DIAGRAM

for LED Type Turn Signal Light (for G16E-GTS)

for LED Type Turn Signal Light (for M20A-FKS, 2ZR-FXE)

for Bulb Type Turn Signal Light

CAUTION / NOTICE / HINT

NOTICE:

  • Inspect the fuses for circuits related to this system before performing the following procedure.
  • Before replacing the main body ECU (multiplex network body ECU), refer to Registration.

    for HV Model:Click here 2023 MY Corolla Corolla HV [09/2022 - 11/2022]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, HV Model): HOW TO PROCEED WITH TROUBLESHOOTING

    for Gasoline Model:Click here 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function (Gasoline Model, except TMMMS Made)): REGISTRATION

  • First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CXPI communication malfunctions before troubleshooting this symptom.

    Click here 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; NETWORKING: CXPI COMMUNICATION SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

PROCEDURE

1.

CONFIRM MODEL

(a) Choose the model to be inspected.

Result

Proceed to

for LED Type Turn Signal Light

A

for Bulb Type Turn Signal Light

B
B

GO TO STEP 3

A

2.

PERFORM ACTIVE TEST USING GTS

(a) Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Daytime Running Light

Daytime running lights

OFF or ON

-

Taillight / Clearance Light

Taillights/parking lights

OFF or ON

-

Body Electrical > Main Body > Active Test

Tester Display

Daytime Running Light

Body Electrical > Main Body > Active Test

Tester Display

Taillight / Clearance Light

OK:

Parking lights and daytime running lights illuminate.

Result

Proceed to

OK

A

NG (LH side parking light or daytime running light does not illuminate)

B

NG (RH side parking light or daytime running light does not illuminate)

C
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE HEADLIGHT ASSEMBLY LH

C

REPLACE HEADLIGHT ASSEMBLY RH

3.

CHECK OPERATION (LOW BEAM HEADLIGHTS)

(a) Check the operation of the low beam headlights.

OK:

The low beam headlights operate normally.

NG

GO TO PROBLEM SYMPTOMS TABLE

OK

4.

PERFORM ACTIVE TEST USING GTS

(a) Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Daytime Running Light

Daytime running lights

OFF or ON

-

Body Electrical > Main Body > Active Test

Tester Display

Daytime Running Light

OK:

Daytime running lights illuminate.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

5.

CHECK HARNESS AND CONNECTOR (POWER DISTRIBUTION BOX ASSEMBLY - HEADLIGHT UNIT ASSEMBLY)

(a) Disconnect the 8F power distribution box assembly connector.

(b) Disconnect the A130 headlight unit assembly LH connector.

(c) Disconnect the A129 headlight unit assembly RH connector.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A130-1 (B) - 8F-2

Always

Below 1 Ω

A129-1 (B) - 8F-2

Always

Below 1 Ω

A130-1 (B) or 8F-2 - Body ground

Always

10 kΩ or higher

A129-1 (B) or 8F-2 - Body ground

Always

10 kΩ or higher
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

6.

INSPECT POWER DISTRIBUTION BOX ASSEMBLY

(a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly.

Click here 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; POWER DISTRIBUTION: MAIN BODY ECU: REMOVAL

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

8F-2 - MB-7 (DRL)

Always

Below 1 Ω
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE POWER DISTRIBUTION BOX ASSEMBLY