Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001WUP8
Model Year Start: 2022 Model: Corolla Hatchback Prod Date Range: [06/2021 - 09/2022]
Title: M20A-FKS (FUEL): FUEL MAIN VALVE (w/o Canister Pump Module (for Double Wishbone Type Suspension)): REMOVAL; 2022 MY Corolla Corolla Hatchback [06/2021 - 09/2022]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel main valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Battery terminal is disconnected/reconnected

Perform steering sensor zero point calibration

Lane Control System (for Gasoline Model)

2019 - 2022 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2022]; PRE-COLLISION: PRE-COLLISION SYSTEM (for Gasoline Model): INITIALIZATION

Pre-collision System (for Gasoline Model)

Lighting System (w/ AFS)(EXT)

CAUTION:

  • Never perform work on fuel system components near any possible ignition sources.
  • Vaporized fuel could ignite, resulting in a serious accident.
  • Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))

PROCEDURE

1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here 2022 MY Corolla Corolla Hatchback [06/2021 - 09/2022]; M20A-FKS (FUEL): FUEL PUMP (w/o Canister Pump Module (for Double Wishbone Type Suspension)): REMOVAL

2. REMOVE FUEL PRESSURE REGULATOR HOLDER

(a) Disengage the 3 claws and remove the fuel pressure regulator holder from the fuel suction tube with pump and gauge assembly.

3. REMOVE FUEL MAIN VALVE ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Pull out the fuel main valve carefully because the O-ring is firmly installed between the fuel main valve and the fuel suction tube with pump and gauge assembly.

*a

Protective Tape

(b) Remove the O-ring from the fuel main valve assembly.

*1

O-ring