Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001KFY5 |
Model Year Start: 2020 |
Model: GR Corolla |
Prod Date Range: [09/2019 - 09/2022] |
Title: AUDIO / VIDEO: RADIO ANTENNA CORD (for Hatchback): REMOVAL; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2019 - 09/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedures
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock*1
|
Power Door Lock Control System
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Click here
3. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
(a) w/ Navigation Antenna:
(1) Disconnect the connector.
|
|
(2) Disengage the 2 claws.
(3) Disengage the clamp.
(b) w/ Manual (SOS) Switch or Navigation ECU:
(1) Disengage the clamp.
*A
|
w/ Manual (SOS) Switch or Navigation ECU
|
-
|
-
|
(c) Disengage the 7 clamps and remove the No. 2 antenna cord sub-assembly.
4. REMOVE ROOF HEADLINING ASSEMBLY
Click here
5. REMOVE NO. 1 ROOF SILENCER PAD
Click here
6. REMOVE NO. 2 ROOF SILENCER PAD
Click here
7. REMOVE ANTENNA CORD SUB-ASSEMBLY
(a) Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape
|
-
|
-
|
(b) Remove the antenna cord sub-assembly from the roof headlining assembly.
8. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER
Click here
9. REMOVE ANTENNA CORD SUB-ASSEMBLY
(a) Disconnect the washer hose.
HINT:
Use a container to collect the windshield washer fluid.
|
|
(b) Disengage the 2 clamps.
(c) Disconnect the connector.
|
|
(d) Disengage the 4 clamps.
(e) Disconnect the washer hose.
HINT:
Use a container to collect the windshield washer fluid.
|
|
(f) Disengage the 8 claws to separate the 2 grommets.
|
|
(g) Remove the antenna cord sub-assembly.
|