Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001HZOY |
Model Year Start: 2020 |
Model: GR Corolla |
Prod Date Range: [03/2019 - 09/2022] |
Title: PARKING BRAKE: PARKING BRAKE LEVER: REMOVAL; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during parking brake lever sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System (for Gasoline Model)
|
|
Pre-collision System (for Gasoline Model)
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock*1
|
Power Door Lock Control System (for Hatchback, Gasoline Model)
|
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))
PROCEDURE
1. REMOVE CONSOLE BOX ASSEMBLY
Click here
2. LOOSEN NO. 1 WIRE ADJUSTING NUT
(a) Release the parking brake lever lock and return it to its off position.
(b) Loosen the No. 1 wire adjusting nut.
|
|
*1
|
No. 1 Wire Adjusting Nut
|
|
|
3. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
Click here
4. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET
(a) Remove the 4 bolts and No. 2 console box mounting bracket.
|
|
5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Separate the No. 3 parking brake cable assembly from the parking brake lever sub-assembly as shown in the illustration.
|
|
*1
|
No. 3 Parking Brake Cable Assembly
|
*2
|
No. 2 Parking Brake Cable Assembly
|
|
|
6. SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT:
Perform the same procedure as for the No. 3 parking brake cable assembly.
7. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
(a) Disconnect the parking brake switch connector.
|
|
(b) Remove the 2 bolts and parking brake lever sub-assembly.
|
|
|