Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001HZML |
Model Year Start: 2020 |
Model: GR Corolla |
Prod Date Range: [03/2019 - 09/2022] |
Title: AUDIO / VIDEO: RADIO RECEIVER: REMOVAL; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2022] |
REMOVAL
PROCEDURE
1. PRECAUTION (for HV Model)
NOTICE:
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly may not operate normally.
NOTICE:
Click here
2. PRECAUTION (for Gasoline Model)
(a) w/o Navigation System:
NOTICE:
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly may not operate normally.
NOTICE:
Click here
(b) w/ Navigation System:
NOTICE:
-
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly or navigation ECU may not operate normally.
-
After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
-
When performing the following work, the navigation system may restart when turning the ignition switch to ACC (due to radio and display receiver assembly and navigation ECU certification).
-
Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.
-
The radio and display receiver assembly or navigation ECU replacement or removal and installation.
NOTICE:
Click here
3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Click here
5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Click here
6. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(b) Pull the radio and display receiver assembly with bracket to disengage the 2 clips.
|
Remove in this Direction
|
(c) Disconnect each connector and remove the radio and display receiver assembly with bracket.
7. REMOVE NO. 1 RADIO RECEIVER BRACKET
(a) Remove the 3 screws and No. 1 radio receiver bracket.
|
|
8. REMOVE NO. 2 RADIO RECEIVER BRACKET
(a) Remove the 3 screws and No. 2 radio receiver bracket.
|
|
9. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
|