| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001HZD5 |
| Model Year Start: 2020 | Model: Corolla | Prod Date Range: [03/2019 - 09/2022] |
| Title: 2ZR-FAE (BATTERY / CHARGING): GENERATOR: REMOVAL; 2020 - 2022 MY Corolla [03/2019 - 09/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during generator assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replacement Part or Procedure |
Necessary Procedures |
Effects / Inoperative when not performed |
Link |
|---|---|---|---|
|
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane Control System (for Gasoline Model) |
|
|
Pre-collision System (for Gasoline Model) |
|||
|
Lighting System (w/ AFS)(EXT) |
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
![2020 - 2022 MY Corolla [03/2019 - 09/2022]; MAINTENANCE: 2ZR-FAE BATTERY: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE V-RIBBED BELT
Click here
3. REMOVE GENERATOR ASSEMBLY
|
(a) Remove the terminal cap. |
|
(b) Remove the nut and disconnect the wire harness from terminal B.
(c) Disconnect the generator assembly connector.
(d) Disengage the wire harness clamp.
|
(e) Remove the 2 bolts and generator assembly. |
|
|
(f) Remove the bolt and wire harness clamp bracket. |
|
|
|