Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001HZCZ |
Model Year Start: 2020 |
Model: Corolla Hatchback |
Prod Date Range: [03/2019 - 09/2022] |
Title: M20A-FKS (BATTERY / CHARGING): GENERATOR (for Transaxle M/T with Denso Made Generator): REMOVAL; 2020 - 2022 MY Corolla Corolla Hatchback [03/2019 - 09/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during generator assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Control System (for Gasoline Model)
|
|
Pre-collision System (for Gasoline Model)
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock*1
|
Power Door Lock Control System (for Hatchback, Gasoline Model)
|
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
2. REMOVE RADIATOR SUPPORT OPENING COVER
-
for Hatchback
Click here
-
w/ Illumination
Click here
3. REMOVE INLET NO. 1 AIR CLEANER
Click here
4. REMOVE V-RIBBED BELT
Click here
5. REMOVE GENERATOR ASSEMBLY
(a) Disconnect the generator assembly connector.
|
|
(b) Open the terminal cap.
(c) Remove the nut and disconnect the wire harness from terminal B.
(d) Remove the bolt and separate the wire harness clamp bracket from the generator assembly.
(e) Remove the 2 nuts bolt and generator assembly.
|
|
|