| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001HYHL |
| Model Year Start: 2020 | Model: Corolla | Prod Date Range: [03/2019 - 09/2022] |
| Title: BRAKE SYSTEM (OTHER): VACUUM PUMP (for TMC Made 2ZR-FAE): REMOVAL; 2020 - 2022 MY Corolla [03/2019 - 09/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum pump assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
| *1: for Hatchback | |||
|
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane Control System |
|
|
Pre-collision System |
|||
|
Lighting System (w/ AFS)(EXT) |
|||
|
Initialize back door lock*1 |
Power Door Lock Control System (for Hatchback) |
|
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System)
PROCEDURE
1. REMOVE BATTERY
Click here
![2020 - 2022 MY Corolla [03/2019 - 09/2022]; MAINTENANCE: 2ZR-FAE BATTERY: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE
|
(a) Slide the clip and disconnect the check valve to connector tube hose from the vacuum pump assembly. |
|
3. REMOVE VACUUM PUMP ASSEMBLY
|
(a) Remove the 3 bolts and vacuum pump assembly. |
|
|
(b) Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly. |
|
|
|