Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM100000001HU89
Model Year Start: 2020 Model: GR Corolla Prod Date Range: [03/2019 - 09/2022]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: PRECAUTION; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2022]

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

  • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
  • When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

    System Name

    See Procedure

    Lane Control System (for Gasoline Model)

    2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2019 - 04/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2021 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [04/2020 - 09/2022]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

    Pre-collision System (for Gasoline Model)

    Lighting System (W/ AFS)(EXT)

    Power Door Lock Control System (for Hatchback, Gasoline Model)

IGNITION SWITCH EXPRESSIONS

(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch

(Position)

Engine Switch

(Condition)

Ignition Switch off

LOCK

Off (Lock)

Ignition Switch ACC

ACC

On (ACC)

Ignition Switch ON

ON

On (IG)

Engine Start

START

On (Start)

PRECAUTION FOR NAVIGATION SYSTEM

NOTICE:

  • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly or navigation ECU may not operate normally.
  • When performing the following work, the navigation system may restart when turning the ignition switch to ACC (due to radio and display receiver assembly and navigation ECU certification).
    • Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.
    • The radio and display receiver assembly or navigation ECU replacement or removal and installation.
  • When replacing the DCM (telematics transceiver), make sure to replace it with a new one (w/ Manual (SOS) Switch).
  • After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
  • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.

(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.

Click here 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2019]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2019 - 04/2020]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION 2021 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [04/2020 - 09/2022]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

  • Radio and display receiver assembly*1
  • DCM (telematics transceiver)*2
  • *1: After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).

    *2: w/ Manual (SOS) Switch