Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001HFSJ
Model Year Start: 2020 Model: Corolla Hatchback Prod Date Range: [01/2019 -           ]
Title: MAINTENANCE: M20A-FKS DRIVE BELT: INSTALLATION; 2020 - 2025 MY Corolla Corolla Hatchback [01/2019 -        ]

INSTALLATION

PROCEDURE

1. INSTALL V-RIBBED BELT

HINT:

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.

(a) Set the V-ribbed belt onto each pulley as shown in the illustration.

*1

Crankshaft Pulley Assembly

*2

Generator Assembly

*3

Compressor Assembly with Pulley

(b) Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.

(c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

*a

Correct

*b

Incorrect

2. INSTALL REAR ENGINE UNDER COVER RH

(a) Type A:

(1) Install the rear engine under cover RH to the vehicle with the screw and 7 clips.

(b) Type B:

(1) Install the rear engine under cover RH to the vehicle with the screw and 8 clips.