Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001HFSJ |
Model Year Start: 2020 |
Model: Corolla Hatchback |
Prod Date Range: [01/2019 -
] |
Title: MAINTENANCE: M20A-FKS DRIVE BELT: INSTALLATION; 2020 - 2025 MY Corolla Corolla Hatchback [01/2019 - ] |
INSTALLATION
PROCEDURE
1. INSTALL V-RIBBED BELT
HINT:
When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.
(a) Set the V-ribbed belt onto each pulley as shown in the illustration.
|
|
*1
|
Crankshaft Pulley Assembly
|
*2
|
Generator Assembly
|
*3
|
Compressor Assembly with Pulley
|
|
|
(b) Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
(c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.
|
|
2. INSTALL REAR ENGINE UNDER COVER RH
(a) Type A:
(1) Install the rear engine under cover RH to the vehicle with the screw and 7 clips.
(b) Type B:
(1) Install the rear engine under cover RH to the vehicle with the screw and 8 clips.
|