Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001HAQ5
Model Year Start: 2020 Model: GR Corolla Prod Date Range: [01/2019 -           ]
Title: DOOR / HATCH: FUEL LID OPENER SYSTEM: DATA LIST / ACTIVE TEST; 2020 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 -        ]

DATA LIST / ACTIVE TEST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

DATA LIST

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine / Data List.

(e) Read the Data List according to the display on the Techstream.

Powertrain > Engine > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Fuel Filler Opener

Fuel lid lock with motor assembly status

OFF or ON

OFF: Fuel lid lock with motor assembly not operating

ON: Fuel lid lock with motor assembly operating

-

Fuel Lid SW

Fuel lid opener switch status

Close or Open

Close: Fuel lid opener switch not pushed

Open: Fuel lid opener switch pushed

-

Fuel Lid Sensor SW

Fuel lid courtesy switch status

Close or Open

Close: Fuel lid closed

Open: Fuel lid open

-

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

ACTIVE TEST

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine / Active Test.

(e) Perform the Active Test according to the display on the Techstream.

Powertrain > Engine > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Activate the Fuel Filler Opener

Fuel lid lock with motor assembly

OFF/ON

-