| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001HAPL |
| Model Year Start: 2020 | Model: Corolla | Prod Date Range: [01/2019 - 09/2022] |
| Title: THEFT DETERRENT / KEYLESS ENTRY: THEFT DETERRENT SYSTEM (for HV Model): Engine Hood Courtesy Switch Circuit; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022] | ||
|
Engine Hood Courtesy Switch Circuit |
DESCRIPTION
The engine hood courtesy switch is built into the hood lock assembly. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
![2020 MY Corolla Corolla HV [01/2019 - 04/2020]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, HV Model): REGISTRATION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (HOOD COURTESY SW) |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Hood Courtesy SW |
Engine hood courtesy switch |
OFF or ON |
OFF: Engine hood closed ON: Engine hood open |
- |
Body Electrical > Main Body > Data List
|
Tester Display |
|---|
|
Hood Courtesy SW |
OK:
The Techstream display changes correctly in response to the engine hood courtesy switch (hood lock assembly) status.
| OK |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
|
|
2. |
INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) |
(a) Remove the hood lock assembly.
Click here
(b) Inspect the engine hood courtesy switch (hood lock assembly).
Click here
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) AND BODY GROUND) |
(a) Disconnect the I85 main body ECU (multiplex network body ECU) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I85-30 (HCTY) - A8-2 (+) |
Always |
Below 1 Ω |
|
I85-30 (HCTY) or A8-2 (+) - Other terminals and body ground |
Always |
10 kΩ or higher |
|
A8-1 (E) - Body ground |
Always |
Below 1 Ω |
| OK |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|