DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM (for HV Model): OPERATION CHECK; 2020 - 2022 MY Corolla Corolla HV [01/2019

Make sure that the vehicle is in an area that allows the wireless control function to operate.

HINT:

The switches described in this text are the switches for transmitting signals. The switches are built into the electrical key transmitter sub-assembly.
All the functions listed below must be checked in comparison with the wireless door lock control operation area.

(a) The operation check below is based on the non-customized initial condition of the vehicle.

(a) Check that the LED of the electrical key transmitter sub-assembly illuminates and turns off 3 times when each switch is pressed and held for 5 seconds.

If the transmitter LED illuminates once or twice but not a third time when the switch has been pressed and held for 5 seconds or more, it may have a weak battery.

(d) Check that the driver door unlocks when the unlock switch is pressed once, and all of the doors unlock when pressed twice within 5 seconds.*

(a) Press and hold the lock or unlock switch on the electrical key transmitter sub-assembly and check that the corresponding operation occurs only once and is not repeated continuously while the switch is held. Then press the switch repeatedly at 1-second intervals, check that the corresponding operation is carried out.

(a) Check that the doors cannot be locked/unlocked by operating a switch on an unregistered electrical key transmitter sub-assembly, but that the doors can be locked/unlocked by operating a switch on the registered electrical key transmitter sub-assembly.

(a) Check that all of the doors attempt to automatically lock 1 second after the lock switch has been pressed while the driver door control knob is being held in the unlock position.

(a) Check that the doors lock automatically if none of the doors have been opened or all of the doors have not been locked within approximately 60*1 or 30*2 seconds of all of the doors being unlocked by pressing the unlock switch.

(b) Check that the automatic locking function does not operate when any door has been opened within approximately 60*1 or 30*2 seconds of unlocking the doors by pressing the unlock switch.

(c) Check that the automatic locking function does not operate when all of the doors have been locked manually (such as using key linked operation, or by pressing the lock switch) within approximately 60*1 or 30*2 seconds of unlocking the doors by pressing the unlock switch.

*1: w/ Door Control Switch Assembly
*2: w/o Door Control Switch Assembly

When the Wireless Lock Function with Doors Open customize setting is set to ON, this function will be disabled even if the Open Door Warning customize setting is set to ON.*

*: w/ Door Control Switch Assembly

(a) Check that the wireless door lock buzzer sounds for approximately 5 seconds when the lock switch is pressed with any of the doors ajar or open.

When the Wireless Lock Function with Doors Open customize setting is set to ON, the door ajar warning buzzer function will be disabled even if the Open Door Warning customize setting is set to ON.

(a) Check that the doors are locked by performing a wireless lock operation with any door open.

(b) Check that answer-back (wireless door lock buzzer) function operates when the wireless operation is performed and answer-back (hazard warning light) function operates when the doors are closed.

(a) When the lock switch is pressed, check that the hazard warning lights flash once simultaneously with the locking operation of all of the doors.

(b) When the unlock switch is pressed, check that the hazard warning lights flash twice simultaneously with the unlocking operation of all of the doors.

(a) When the lock switch is pressed, check that the buzzer sounds once simultaneously with the locking operation of all of the doors.

(b) When the unlock switch is pressed once, check that the buzzer sounds twice simultaneously with the unlocking operation of the driver door.