Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM100000001H6TP
Model Year Start: 2020 Model: Corolla Prod Date Range: [01/2019 - 09/2022]
Title: P610 (HYBRID TRANSMISSION / TRANSAXLE): SHIFT LEVER POSITION SENSOR: REMOVAL; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]

REMOVAL

PROCEDURE

1. SECURE VEHICLE

(a) Fully apply the parking brake and chock a wheel.

CAUTION:

  • Make sure to apply the parking brake and chock a wheel before performing this procedure.
  • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here 2020 MY Corolla Corolla HV [01/2019 - 04/2020]; 2ZR-FXE (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+ 2021 - 2022 MY Corolla Corolla HV [04/2020 - 09/2022]; 2ZR-FXE (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+

3. DISCONNECT FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE

(a) Move the shift lever to N.

(b) Remove the nut and disconnect the floor shift transmission control select cable from the control shaft lever.

(c) Remove the clip and disconnect the floor shift transmission control select cable from the No. 1 transmission control cable bracket.

4. REMOVE SHIFT LEVER POSITION SENSOR

(a) Disconnect the shift lever position sensor connector.

(b) Remove the nut, washer and control shaft lever from the shift lever position sensor.

(c) Using a screwdriver with its tip wrapped with protective tape, pry out the tabs of the lock plate.

*1

Lock Plate

*a

Protective Tape

(d) Remove the lock nut and lock plate from the shift lever position sensor.

*1

Lock Nut

*2

Lock Plate

(e) Remove the 2 bolts and shift lever position sensor from the hybrid vehicle transaxle assembly.

5. REMOVE SHIFT LEVER POSITION SENSOR SEAL

HINT:

Perform this procedure only when replacement of the shift lever position sensor seal is necessary.

(a) Using a screwdriver with its tip wrapped in protective tape, remove the shift lever position sensor seal from the hybrid vehicle transaxle assembly.

NOTICE:

When removing the shift lever position sensor seal, make sure not to damage the parking lock shaft or transaxle case.

*a

Protective Tape