Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001H6T5
Model Year Start: 2020 Model: Corolla Prod Date Range: [01/2019 - 09/2022]
Title: P610 (HYBRID TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: REMOVAL; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during floor shift transmission control select cable removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Gas leak from exhaust system is repaired

Inspection After Repair
  • Poor idle, etc.
  • Engine start function, etc.

2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

PROCEDURE

1. SECURE VEHICLE

(a) Fully apply the parking brake and chock a wheel.

CAUTION:

  • Make sure to apply the parking brake and chock a wheel before performing this procedure.
  • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

2. REMOVE CONSOLE BOX ASSEMBLY

Click here 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV [01/2019 - 09/2022]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (except G16E-GTS): REMOVAL

3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here 2020 MY Corolla Corolla HV [01/2019 - 04/2020]; 2ZR-FXE (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+ 2021 - 2022 MY Corolla Corolla HV [04/2020 - 09/2022]; 2ZR-FXE (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+

4. REMOVE FRONT FLOOR COVER LH

Click here 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (INTAKE / EXHAUST): EXHAUST MANIFOLD: REMOVAL+

5. REMOVE FRONT FLOOR COVER RH

HINT:

Use the same procedure as for the LH side.

6. REMOVE FRONT FLOOR CENTER BRACE

Click here 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (INTAKE / EXHAUST): EXHAUST MANIFOLD: REMOVAL+

7. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Click here 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (INTAKE / EXHAUST): EXHAUST MANIFOLD: REMOVAL+

8. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

(a) Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.

9. REMOVE FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE

(a) Move the shift lever to N.

(b) Disconnect the floor shift transmission control select cable from the transmission floor shift assembly.

(c) Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the floor shift transmission control select cable from the transmission floor shift assembly.

NOTICE:

Do not forcibly pull the floor shift transmission control select cable into the cabin.

*a

Counterclockwise

*b

Lock Nut

(d) Remove the nut and disconnect the floor shift transmission control select cable from the control shaft lever.

(e) Remove the clip and disconnect the floor shift transmission control select cable from the No. 1 transmission control cable bracket.

(f) Disconnect the floor shift transmission control select cable from the transmission control cable support.

(g) Remove the bolt and disconnect the floor shift transmission control select cable from the engine assembly.

(h) Remove the nut and disconnect the floor shift transmission control select cable from the vehicle body.

(i) Remove the 2 nuts and floor shift transmission control select cable from the vehicle body.