Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001H4YG |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 -
] |
Title: 2ZR-FXE (ENGINE CONTROL): AIR FUEL RATIO SENSOR: REMOVAL; 2020 - 2025 MY Corolla Corolla HV [01/2019 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Replacement of air fuel ratio sensor
-
Gas leak from exhaust system is repaired
|
Inspection After Repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Click here
2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL
Click here
3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
4. REMOVE AIR FUEL RATIO SENSOR
CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
(a) Disconnect the air fuel ratio sensor connector.
|
|
(b) Disengage the 2 wire harness clamps.
(c) Using SST, remove the air fuel ratio sensor from the exhaust manifold (TWC: Front Catalyst).
SST: 09224-00012
NOTICE:
If the air fuel ratio sensor has been struck or dropped, replace it.
|
|
|