Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001H4YC
Model Year Start: 2020 Model: Corolla Prod Date Range: [01/2019 -           ]
Title: 2ZR-FXE (ENGINE CONTROL): KNOCK SENSOR: REMOVAL; 2020 - 2025 MY Corolla Corolla HV [01/2019 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
  • Replacement of throttle body assembly
  • Cleaning the deposits from the throttle body assembly
  • Replacement of knock control sensor

Inspection After Repair
  • Poor idle, etc.
  • Engine start function, etc.

2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION 2023 - 2025 MY Corolla Corolla HV [09/2022 -        ]; 2ZR-FXE (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE INTAKE MANIFOLD

Click here 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]; 2ZR-FXE (INTAKE / EXHAUST): INTAKE MANIFOLD: REMOVAL 2023 - 2025 MY Corolla Corolla HV [09/2022 -        ]; 2ZR-FXE (INTAKE / EXHAUST): INTAKE MANIFOLD: REMOVAL

2. REMOVE KNOCK CONTROL SENSOR

(a) Disconnect the knock control sensor connector.

(b) Remove the bolt and knock control sensor from the cylinder block sub-assembly.

NOTICE:

If the knock control sensor has been struck or dropped, replace it.