Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001H4YC |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 -
] |
Title: 2ZR-FXE (ENGINE CONTROL): KNOCK SENSOR: REMOVAL; 2020 - 2025 MY Corolla Corolla HV [01/2019 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Replacement of throttle body assembly
-
Cleaning the deposits from the throttle body assembly
-
Replacement of knock control sensor
|
Inspection After Repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. REMOVE INTAKE MANIFOLD
Click here
2. REMOVE KNOCK CONTROL SENSOR
(a) Disconnect the knock control sensor connector.
|
|
(b) Remove the bolt and knock control sensor from the cylinder block sub-assembly.
NOTICE:
If the knock control sensor has been struck or dropped, replace it.
|