Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001H4Y2 |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 -
] |
Title: 2ZR-FXE (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: INSTALLATION; 2020 - 2025 MY Corolla Corolla HV [01/2019 - ] |
INSTALLATION
PROCEDURE
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
NOTICE:
If reusing the crankshaft position sensor, check the O-ring.
(b) Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
-
Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.
-
If the crankshaft position sensor has been struck or dropped, replace it.
(c) Connect the crankshaft position sensor connector.
2. INSPECT FOR ENGINE OIL LEAK
Click here
3. INSTALL REAR ENGINE UNDER COVER RH
(a) Type A:
(1) Install the rear engine under cover RH to the vehicle with the screw and 7 clips.
(b) Type B:
(1) Install the rear engine under cover RH to the vehicle with the screw and 8 clips.
|