2ZR-FXE (ENGINE CONTROL): CAMSHAFT POSITION SENSOR: INSTALLATION; 2020 - 2025 MY Corolla Corolla HV [01/2019

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM100000001H4XW
Model Year Start: 2020	Model: Corolla	Prod Date Range: [01/2019 - ]
Title: 2ZR-FXE (ENGINE CONTROL): CAMSHAFT POSITION SENSOR: INSTALLATION; 2020 - 2025 MY Corolla Corolla HV [01/2019 - ]

INSTALLATION

1. INSTALL CAMSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing a camshaft position sensor, check the O-ring.

(b) Temporarily install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

NOTICE:

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
If a camshaft position sensor has been struck or dropped, replace it.

*a	Torque Wrench Fulcrum Length
*b	10 mm Union Nut Wrench

Torque:

Specified tightening torque :

10 N·m {102 kgf·cm, 7 ft·lbf}

HINT:

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click here
When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
8.8 N*m (90 kgf*cm, 78 in.*lbf)

(d) Connect the camshaft position sensor connector.

(e) Connect the No. 1 fuel vapor feed hose to the fuel vapor feed pipe.

2. INSPECT FOR ENGINE OIL LEAK

Click here