Even when the wireless charging system is turned on, the indicator light (green) does not illuminate

Wireless charger power source circuit

Mobile wireless charger cradle assembly

When the wireless charging system is turned on, the indicator (green) illuminates, but the indicator (amber) does not illuminate when a rechargeable device is placed on the charging area (wireless charging does not start)

Check that the device being used is a Qi-compatible rechargeable device

-

Remove any cases and accessories

-

Check that there is no gap between the rechargeable device and the charging area

-

Check that there is no foreign matter between the rechargeable device and the charging area

-

Check that the rechargeable device is not fully charged

-

Check that the rechargeable device is centered on the charging area

-

Check that the rechargeable device is placed on the charging area with its charging surface facing down

-

Check that the vehicle is not in an environment where it may be affected by strong radio waves or electrical noise

-

Check if more than 1 rechargeable device is placed on the charging area

-

Check that a charging cable is not connected to the rechargeable device

-

Check that temperature of the rechargeable device is not excessively high or low

-

Check if wireless charging of the rechargeable device is possible using another Qi-compatible wireless charging system

-

Check if wireless charging is possible using another Qi-compatible rechargeable device

-

Status signal circuit*1

Mobile wireless charger cradle assembly

When the wireless charging system is turned on, the indicator (green) illuminates and when a rechargeable device is placed on the charging area, the indicator (amber) illuminates, but the indicator (green) illuminates again before wireless charging is completed (wireless charging does not complete)

Check if the rechargeable device has not been moved out of the charging area

-

Check that temperature of the rechargeable device is not excessively high or low

-

Check that the vehicle is not in an environment where it may be affected by strong radio waves or electrical noise

-

Status signal circuit*1

Mobile wireless charger cradle assembly

When the taillight on, the mobile wireless charger switch does not illuminate

Wireless charger illumination circuit

Mobile wireless charger cradle assembly

The mobile wireless charger switch does not dim when the rheostat is operated

Wireless charger illumination circuit

Mobile wireless charger cradle assembly

The indicator light (amber) blinks (pattern 1)*3

Status signal circuit*1

Wire harness or connector*2

-

Mobile wireless charger cradle assembly

The indicator light (amber) blinks (pattern 2)*3

Check if the charging frequency is being changed

Mobile wireless charger cradle assembly

The indicator light (amber) blinks (pattern 3)*3

Check that the device being used is a Qi-compatible rechargeable device

-

Remove any cases and accessories

-

Check that there is no gap between the rechargeable device and the charging area

-

Check that there is no foreign matter between the rechargeable device and the charging area

-

Check that the rechargeable device is centered on the charging area

-

Check that the rechargeable device is in the same position as when charging was started

-

Mobile wireless charger cradle assembly

The indicator light (amber) blinks (pattern 4)*3

Check that temperature of the mobile wireless charger cradle assembly is not excessively high

-

Mobile wireless charger cradle assembly