- Replacement of air fuel ratio sensor
- Gas leak from exhaust system is repaired
| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001GYKP |
| Model Year Start: 2020 | Model: Corolla | Prod Date Range: [01/2019 - 11/2022] |
| Title: 2ZR-FAE (ENGINE CONTROL): AIR FUEL RATIO SENSOR: REMOVAL; 2020 - 2023 MY Corolla [01/2019 - 11/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
PROCEDURE
1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)
Click here
![2020 - 2023 MY Corolla [01/2019 - 11/2022]; 2ZR-FAE (INTAKE / EXHAUST): EXHAUST PIPE: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
|
(a) Remove the 3 nuts and front No. 1 floor heat insulator from the vehicle body. |
|
3. REMOVE AIR FUEL RATIO SENSOR
CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
|
(a) Disconnect the air fuel ratio sensor connector. |
|
(b) Disengage the 2 clamps.
|
(c) Using SST, remove the air fuel ratio sensor from the exhaust manifold. SST: 09224-00012 NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it. |
|
|
|