(1) Using an air blow gun, clean the intake air temperature sensor (thermistor) area of the mass air flow meter sub-assembly by applying approximately 10 intermittent bursts of air to the intake air temperature sensor (thermistor) area at a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm2, 57 to 142 psi).
HINT:
After performing cleaning, read the value of Data List item "MAF" using the Techstream and if the value is not as specified, replace the mass air flow meter sub-assembly.
|
|
*a
|
Air Blow Duration
|
*b
|
3 to 6 Seconds
|
*c
|
1 Second
|
*d
|
Air Blowing
|
*e
|
Air Stopped
|
|
|