Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GYJN |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 - 11/2022] |
Title: 2ZR-FAE (ENGINE CONTROL): THROTTLE BODY: REMOVAL; 2020 - 2023 MY Corolla [01/2019 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Replacement of throttle body assembly
-
Cleaning the deposits from the throttle body assembly
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
(a) Disconnect the mass air flow meter sub-assembly connector and disengage the wire harness clamp.
|
|
*a
|
Wire Harness Clamp
|
*b
|
Clamp
|
*c
|
Guide
|
|
|
(b) Disengage the 2 clamps and 2 guides.
(c) Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.
(d) Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body assembly.
3. REMOVE THROTTLE BODY ASSEMBLY
(a) Disconnect the throttle body assembly connector.
|
|
*1
|
Water By-pass Hose
|
*2
|
No. 2 Water By-pass Hose
|
|
|
(b) Slide the 2 clips and disconnect the water by-pass hose and No. 2 water by-pass hose from the throttle body assembly.
(c) w/ Stud Bolt:
(1) Remove the 2 bolts, 2 nuts and throttle body assembly from the intake manifold.
NOTICE:
If the throttle body assembly has been struck or dropped, replace it.
|
|
*A
|
w/ Stud Bolt
|
*B
|
w/o Stud Bolt
|
|
|
(d) w/o Stud Bolt:
(1) Remove the 4 bolts and throttle body assembly from the intake manifold.
NOTICE:
If the throttle body assembly has been struck or dropped, replace it.
4. REMOVE THROTTLE BODY GASKET
(a) Remove the throttle body gasket from the intake manifold.
|
|
|