Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000001GY4S
Model Year Start: 2020 Model: GR Corolla Prod Date Range: [01/2019 - 11/2022]
Title: EXTERIOR PANELS / TRIM: REAR BUMPER (for Sedan): REMOVAL; 2020 - 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 11/2022]

REMOVAL

CAUTION / NOTICE / HINT

HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click here 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: ADJUSTMENT 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2022]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: ADJUSTMENT 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: ADJUSTMENT

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT COVER LH

Click here 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019]; LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY (for Sedan): REMOVAL+ 2020 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 -        ]; LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY (for Sedan): REMOVAL+

2. REMOVE REAR COMBINATION LIGHT COVER RH

HINT:

Use the same procedure as for the LH side.

3. REMOVE REAR BUMPER ASSEMBLY

(a) Apply protective tape around the rear bumper assembly as shown in the illustration.

Protective Tape

(b) Remove the 2 screws.

(c) Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.

(d) w/o Rear Under Cover:

(1) Remove the 4 clips.

(e) w/ Rear Under Cover:

(1) Remove the 9 clips.

(f) Disengage the 8 claws as shown in the illustration.

Place Hand Here

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(g) Disengage the 4 claws as shown in the illustration to remove the rear bumper assembly.

Remove in this Direction